![]() The way it works is that I just "enable" the router functionality and then. I recently realized that I have a switch configuration with an unintended potential side-effect.I have an Aruba 6300F with several VLANs on it. for your first question the disconnection can cause flapping state, in most cases duplex mismatch between switch port and cable modem. ![]() Can I plug the mgmt interface of a switch into one of its own switch ports? Networking.What could an IT Pro do with superpowers? Which IT tasks would you use them in and how? Which Superpowers Would You Like to Have? Water Cooler.Install transceiver or loopback module into switch. How to perform and confirm a loopback test using a single strand of fiber: 1. Remove collar and isolate both ends of the same strand of cable. Review the interfaces status to confirm the working status of all ports on the switch. Creating a single strand of fiber out of a duplex cable takes a couple of extra steps. Check the software version of the switch. At this step, you can examine whether the port and transceiver parameters are normal. ![]() Satellite networks are at high risk, according to a new warning from the FBI and CISA. Connect your transceiver with one simplex fiber cable or loopback cable, such as LC fiber cable or LC loopback cable. ![]() Snap! SATCOM Threat, IE End of Life, Bricked Macs, Planet 9, Lego Delorean Spiceworks OriginalsįBI and CISA warn over threats to satellite communications networks. ![]() But, they did something I've been wanting for years (decades?), so I guess there needs to be acknowledgement. I could give a "He Tasks Me" speech like Khan in "Star Trek II: The Wrath of Khan".
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |